My system was working flawlessly with 0.9.1 for those few months since 0.9.1 was released.
I went through system logs, and there are only two entries that have anything to do with PrimoCache.
One was logged when I think the system was going down for reboot (I clicked the "Restart Now" in PrimoCache installator):
The PrimoCache Service service is marked as an interactive service. However, the system is configured to not allow interactive services. This service may not function properly.
The other one was logged after I removed PrimoCache in Windows safe mode, and the system was finally booting correctly:
The description for Event ID 1 from source FancyCcV cannot be found. Either the component that raises this event is not installed on your local computer or the installation is corrupted. You can install or repair the component on the local computer.
If the event originated on another computer, the display information had to be saved with the event.
The following information was included with the event:
Binary data:
In Words
0000: 00080000 00000001 00000000 E0060001
0008: 00000001 00000000 00000000 00000000
0010: 00000000 00000000 079B49B0 FFFFFA80
In Bytes
0000: 00 00 08 00 01 00 00 00 ........
0008: 00 00 00 00 01 00 06 E0 .......à
0010: 01 00 00 00 00 00 00 00 ........
0018: 00 00 00 00 00 00 00 00 ........
0020: 00 00 00 00 00 00 00 00 ........
0028: B0 49 9B 07 80 FA FF FF °I.úÿÿ
