Romex Software Forum

Posted: **Sat Sep 13, 2014 9:36 pm**

Hi,

I have 2x 4TB HHDs in mirrored and 2x 500GB SSDs in a stripped. I want to use 60 GB of my SSDs for L2 cache of my HHDs. Whenever I try to set it up it showing both SSD drives. Should I split of the L2 cache between two drives? What is the best way to allocate a L2 cache on this drives? Thanks!

Posted: **Sun Sep 14, 2014 10:05 am**

Are you using Windows' software RAID (set up using Disk Manager) or firmware RAID (using either a motherboard RAID chipset or an add-in card)? Firmware RAID setups should appear as a single entry for PrimoCache, so if you're using Windows RAID then try firmware - if available.

Posted: **Wed Sep 17, 2014 1:28 pm**

My suggestion is to split the caches. Just make sure the RAID controller (assuming software) is aware or at least tolerant of the space reserved for this purpose.

Romex Software Forum

Using L2 Cahce on a RAID 0 SSD

Using L2 Cahce on a RAID 0 SSD

Re: Using L2 Cahce on a RAID 0 SSD

Re: Using L2 Cahce on a RAID 0 SSD