On Active Defer-Write ( ENABLE )
And latency set to INFINITE + Write Mode Average
Can u Set Speed ( Average ) of flush data ( ADD THIS OPTION )
Now, Software do it about 45Mb/s
I like change this value.
And can add another option,
When HDD READ above X speed don't flush any Defer Write to avoid hdd seek.
Performance incresse
Thanks,
RATE of Defer-Write and pause flush when HDD Read *Avoid seek / Performance incresse
-
- Level 1
- Posts: 4
- Joined: Wed Jun 26, 2019 12:17 pm
Re: RATE of Defer-Write and pause flush when HDD Read *Avoid seek / Performance incresse
I'm sorry that this is not a pre-defined value. It depends on how much deferred write-data accumulated during the time window. In the average mode, PrimoCache flush the data by a complicated algorithm to make the drive able to handle heavy writing streams. It's not easy to add a tunable parameter of speed.danieldurio wrote: ↑Wed Jun 26, 2019 12:21 pm Now, Software do it about 45Mb/s
I like change this value.
danieldurio wrote: ↑Wed Jun 26, 2019 12:21 pm When HDD READ above X speed don't flush any Defer Write to avoid hdd seek.
Thank you for the suggestion. We're also thinking about this to avoid simultaneous reading and writing on HDDs.