Ramdisk is deleted when I reboot the labtop.

[elkha]

Windows 10
labtop
primo ramdisk 6.1.0

I created ramdisk when the second monitor is connected.

I disconnected the monitor and reboot the labtop, then the ramdisk does not created.

I tried to create ramdisk again, but the ramdisk was created only one time.

Ramdisk is deleted when I reboot the labtop.

[Support]

Make sure that the option "volatile" is not checked in the ramdisk configuration dialog. If it is not checked and the problem still exists, you may update the program to the latest v6.3.1 and then check if it helps.
For the updating, you don't need to uninstall the old version. Just download the latest setup program and then run the installer.

[elkha]

Thank you for response.
But the problem is not solved.
I installed lastest version and I did not check the volatile.
The ramdisk partition was not exists when I reboot the labtop.

[Support]

Do you install any software which blocks writing of registry or Windows partition?
Could you please upload a screenshot of the Primo Ramdisk main dialog which shows the configuration?
Thanks.