Romex Software Forum

@HotLasagna, it's designed for the L2 clear issue on ungraceful shutdowns, but I think it shall also work for your case.

Any chance to see a 4.0 final release soon?

dhstsw wrote: ↑Thu Sep 03, 2020 11:58 am Any chance to see a 4.0 final release soon?

I'm sorry for the delay in the release of new version. We are adding some new features and will do our best.

Hi Support.

Is possible to post the changelogs of features that will be added final version. This would keep people from asking and wondering if the development had stop or work on primocache. I know have asked similar questions in the past, and your guys want to make sure the the software is bug free before release.

I rather have stable release version and not a buggy one. Fancycache and Primocache v1 v2 and early versions of Win10 was nightmare on my test laptop. Anyway, ur software is awesome and so have been ur support.

@minhgi, here are some major features to be added:
1. Support 4Kn drives.
2. Support L2 cache greater than 2TB.
These two features require modifications on the program's code architecture, so we have to do them carefully.
We will also have some improvements on L2 cache and defer-write, as well as bug fixes.
Thanks.

Support wrote: ↑Mon Sep 07, 2020 1:30 am We will also have some improvements on L2 cache and defer-write, as well as bug fixes.

Will you be adding the feature where if there is write data in L1 that it will also be written to L2 during L2 write?

RobF99 wrote: ↑Tue Sep 08, 2020 9:38 am Will you be adding the feature where if there is write data in L1 that it will also be written to L2 during L2 write?

I'm sorry this feature may not come out in the next version. It will come out later.

Any plans on adding an exclude/include functionality for which caching should be stopped when running any of the .exe processes on the excluded list? Would be nice to tick for stats reset, like I'm running now by .bat command for certain programs:

rxpcc.exe pause -a -s

rxpcc.exe resume -a -s
rxpcc.exe perf -a -r -s

but not all of the programs I'm using have the possibility for using the command line and if they do like Auslogics Disk Defrag, the list of commands is cheap, other takes time to find, workaround etc. etc. so it would be nice to have this functionality in 4.0 release. It can't be too hard to implement, isn't it?

You can reset the statistics in PrimoCache GUI, please see the "Cache Statistics & Performance Monitor" section in the following page.
https://www.romexsoftware.com/en-us/pri ... rview.html

Well... that wasn't the point with my post...